SciELO - Scientific Electronic Library Online

 
vol.26 número1Caracterización de la rugosidad superficial y de la energía de corte durante el maquinado de Pinus radiataInfluencia de la madera juvenil de pino radiata sobre las propiedades físicas y mecánicas de tableros OSB índice de autoresíndice de materiabúsqueda de artículos
Home Pagelista alfabética de revistas  

Servicios Personalizados

Revista

Articulo

Indicadores

Links relacionados

Compartir


Bosque (Valdivia)

versión On-line ISSN 0717-9200

Resumen

KARSULOVIC C, JOSE TOMAS et al. Determination of cylindrical defective core diameter in pruned Pinus radiata (D. Don) logs using gamma radiation attenuation. Bosque (Valdivia) [online]. 2005, vol.26, n.1, pp.109-122. ISSN 0717-9200.  http://dx.doi.org/10.4067/S0717-92002005000100011.

This research, supported by FONDECYT Project # 1990680, focused on the feasibility of the gamma ray attenuation method as a means of detecting the defective core size in commercial Pinus radiata (D. Don) pruned logs. The sample consisted of two 5 m commercial logs from the same tree which came from a 24 year old planting by Bosques Arauco S.A. The system arrayed in the Laboratory of Ionic Beams in the Faculty of Sciences of the University of Chile allowed the establishment of a precise geometry for the irradiation stage, reaching close to the preferred unit value for the build-up factor. In order to have precedence records for the effect of singularities (knots) in the attenuation, a simulation of the log using round plastic containers was carried out. This also allowed a comparison of results with the main experiment. An irradiation of the logs took place in three parallel planes at three different elevations with a collection time of 220 seconds per reading. The data on the attenuation was compared with the actual locations of defects plotted through progressive transverse sectioning of the logs. Subestimations determined the defect core size to be from 0.5 to 2.9 cm in diameter. The feasibility of this method to identify the knots in commercially shaped logs was demonstrated. Nevertheless, the accuracy of this method is not optimal, owing to the time required for each radiation. However, a reduced time-span may be possible by using stronger radioactive sources as well as thinner logs.

Palabras clave : gamma radiation; defect core size; radiata pine.

        · resumen en Español     · texto en Español     · Español ( pdf )

 

Creative Commons License Todo el contenido de esta revista, excepto dónde está identificado, está bajo una Licencia Creative Commons