SciELO - Scientific Electronic Library Online

 
vol.33 número3Morfología Acromial y Arquitectura Subacromial en una Población SudafricanaParámetros Antropométricos de Cadetes entre los Diferentes Deportes Militares índice de autoresíndice de materiabúsqueda de artículos
Home Pagelista alfabética de revistas  

Servicios Personalizados

Revista

Articulo

Indicadores

Links relacionados

  • En proceso de indezaciónCitado por Google
  • No hay articulos similaresSimilares en SciELO
  • En proceso de indezaciónSimilares en Google

Compartir


International Journal of Morphology

versión On-line ISSN 0717-9502

Resumen

DE MORAES, Paulo Hemerson et al. Anatomical Reproducibility through 3D Printing in Cranio-Maxillo-Facial Defects. Int. J. Morphol. [online]. 2015, vol.33, n.3, pp.826-830. ISSN 0717-9502.  http://dx.doi.org/10.4067/S0717-95022015000300003.

The planning and 3D reconstruction in craniofacial defects based on anatomical principles of symmetry and passive adaptation has evolved radically the past few years. This article recounts the possibility to develop personalized and extensive craniofacial implants. We present a case of a patient with a 10-year trauma sequel evolution; the patient lost the right frontal bone, supraorbital wall and part of the temporal fossa. From the computerized tomography, and by using Materialise software (3-Matic and Mimics). Subsequently, the printing was performed using the virtual planning with a laser printer in titanium where the piece was elaborated with the determined specifications in the planning; surgery was performed without complications in which the implant was placed via a coronal approach, which did not require any type of adaptation. After a two-year follow-up we observed a correct position, symmetry, absence of infection or any other alteration. It is concluded that the planning and 3D printing are suitable to perform craniofacial reconstructions with a low morbidity, shorter surgical time, and with an adequate facial symmetry and aesthetic return.

Palabras clave : 3D printing; Selective laser melting; Facial implant.

        · resumen en Español     · texto en Inglés     · Inglés ( pdf )

 

Creative Commons License Todo el contenido de esta revista, excepto dónde está identificado, está bajo una Licencia Creative Commons